As a vehicle’s engine runs, fuel is transformed into energy which produces a great deal of heat. To prevent the vehicle's motor from burning up, a cooling system has been added to the mix. This mechanism tones down the temperature and keeps it regulated.

Made up of several parts - including the radiator, hoses, thermostat, and water pump - this features contains a mixture of antifreeze (coolant) and water. constantly flowing throughout the system it drops the temperature down to prevent an excessive buildup of heat. If this component is not functioning properly, severe damage can be incurred.

Check your car’s coolant system by performing the following actions:

• Drain - Allowing the old fluid to be removed, simple draining will eliminate contaminated liquid and particles.
• Check the Thermostat - Aging models will eventually fail. Without a working thermostat, you have no way of knowing how hot the engine is.
• Refill - If the component is low on fluid, topping it off could be the solution.
• Run a System Analysis - If you did the two things listed above and there is still an issue, you will need to have a mechanic run a total system analysis to identify the source of the problem.

Need coolant system parts? Contact the experts at Ford Parts BC to find the right pieces.

The heart of every vehicle on the road is its engine. Responsible for transforming fuel into energy to move the automobile and provide power to all of the functioning mechanics, the motor is made up of several intricate parts. All of these need to be working in unison to complete the task at hand.

The main components include the block, head, valves, cams, crank, rods, pistons, intake/exhaust systems, and ignition.

First, the block is a large chunk of metal found on the centre section of the engine bay. It has circular holes (cylinder bores) for the piston to move through and several wires and tubes are attached here as well. The head - which is usually crafted from aluminum - is also located here. It houses spark plugs, valves, springs, camshafts, and retainers.

Next, the valves are pieces of the intake and exhaust systems. They look like golf tees, and they serve as doorways for inching fuel/air and outgoing gases. Then, there is the crank. Its job is to move the pistons up and down.

These pistons are secured to a connecting rod that links them to the crankshaft. Finally, the ignition is an electronic component that causes the air/fuel mixture inside the engine to combust.

Contact Ford Parts BC to find replacement pieces for your motor!

For every Ford vehicle, there are three main components to a wheel. Although these sets vary in size and style, they all perform the same function. That is enabling the car, truck, van, or SUV to move from one place to another.

The first part of the wheel is the tire. Crafted from strips of rubber, these provide traction and grip of different degrees. This mainly depends on the type of tire you have. These can include all-season (the most popular), performance, off-roading, and more.

Next is the rim. Serving as the skeleton of the wheel, this is what the tire is wrapped around. Base trim levels typically come with steel models, and higher versions are usually crafted out of aluminum or alloy. Different finishes are available including plastic protective covers, shiny chrome, and so much more.

Finally, the hub is the centre cap of the wheel that attaches the rim to the axle, rotors, calipers, and brake pads. In the middle section, you will find five bolts along with lug nuts that keep everything together.

Do you need replacement elements for your set of wheels? Get in touch with the experts at Ford Parts BC to start an order.

No matter what model you have, every vehicle comes with a gear shifter. While newer automobiles may have rotary dials, the vast majority of cars, trucks, vans, and SUVs have a knob-style version.

Allowing the vehicle to be put into different gears, the shifter is typically located in the middle of the two front seats. Sometimes, automatics may be on the righthand side of the steering wheel.

There are two types of shifters - manual and automatic. The manual unit works in unison with a clutch. You must step on the clutch pedal to disengage the gearbox from the motor. Next, you move the shifter into the appropriate gear and release the clutch. On the other hand, the automatic uses an onboard computer to complete the same task. The disengagement doesn’t have to be done manually, and no clutch is necessary.

One thing you may not be aware of is that you can swap out the knob on these components. Whether you are going for hand comfort or a style change-up, you can replace your current knob with an OEM part. There are many different designs to choose from as well.

Get in touch with the staff at Ford Parts BC to learn more!

When it comes to customization, there are plenty of options with the Ford lineup. One of the things you can add to your vehicle is a set of door sills. But what exactly are they, and what do they do?

Door sills serve as a protective modification that is easy to install. Attaching seamlessly to the inner base of your vehicle’s doors, they are small, slender, and act as mats for the entry points. They also provide a stable base for riders to step on as they climb into the cabin.

Constructed out of a heavy-duty film, they can be secured to the door jamb with a commercial-grade adhesive. Protecting the vehicle’s body from impacts, your paint job will last a lot longer. These pieces also shield against dirt smudges, abrasions from shoes, scratches, and even scuffs.

How long the sills will last depends on usage and exposure to the elements. Moisture from rain or car washes can cause these components to wear down faster. You can simply wipe them down once a week to ensure that they are still in good condition and performing their job properly.

Ready to get a set of OEM door sills? Contact Ford Parts BC today!

Floor mats are designed to shield a vehicle’s ground from stains, moisture, and dirt. They can keep the car looking newer and cleaner as well.

Adding floor mats is easy and quick. They can be removed within seconds, washed, and replaced. Some may also have fixation points and pre-installed anchors that prevent them from shifting positions. These can come in the form of hooks, clips, or twists. Others may have small spikes on the underside to grip the carpet beneath.

Materials used to produce these mats are typically either carpet or rubber. Carpet versions usually come with rubberized backings to keep them from slipping. Meanwhile, the full rubber units are more durable and perfect for people who frequently hit the trails. These are the most popular since they are waterproof and tend to last a lot longer.

There are many different classifications for floor mats including all-season, all-weather, luxury, tactical, and more. For Ford models, you can get just about any of these to protect your footwells. Some sets only come with pieces for the front. However, you can get assemblies that contain components for even the largest SUVs.

Contact the team of experts at Ford Parts BC to learn more!

Typically seen on sporty cars, a rear spoiler is an added fin that changes the direction of the airflow to reduce wind resistance. Crafted to improve the overall efficiency, speed, and agility of a vehicle, it sits down on drag and can even provide better grip across the pavement.

Although this element is popular on race cars and high-performance models, it can also be seen on some SUVs and sedans. This is mainly because it raises the average fuel economy on the highway.

There are several different types of spoilers. The most common is the wind-shaped component that sits above the back decklid. Next is the front spoiler that is designed to push air to the sides instead of underneath. Side skirts are another form that are paired with rocker panels.

As your speed increases, so does the total drag. In turn, this makes the engine work a lot harder to maintain that high speed. As air travel under the car, lift is generated which reduces the amount of grip (traction) you have on the street. The main purpose of a spoiler is to eliminate that issue.

The Mustang is a legendary muscle car that comes with a spoiler. If you want to replace yours, contact Ford Parts BC to find the right piece!

There are hundreds of various parts that go into manufacturing a Ford vehicle. One of these is the valance panel. Sometimes referred to as the bumper valance, this thin, slim piece is situated under the front bumper.

The sole purpose of the component is aerodynamics and fuel efficiency. Depending on its placement, it can function similarly to an air dam by directing the airflow underneath the car. Furthermore, it can also be a larger unit that has been integrated into the airflow lip at the bottom.

Some automobiles may have two valance panels - one in the front and another on the back. In this case, these do not cover the full width of the chassis. They are known as corner pieces. Other versions of the valance panel may simply be there to cover exposed parts such as the radiator. Bridging the gap between the dual exhaust pipes is another job that this element can do.

Older models may have steel valance panels, but newer ones are typically built from plastic. This helps keep the overall weight lighter, which means better gas mileage. They are also much easier to replace.

Need a new valance panel? Get in touch with the team at Ford Parts BC to purchase the appropriate piece!

A small, battery-powered motor is responsible for getting the engine of your vehicle going. It is known as the starter system. Also featuring a relay that transmits the energy, both pieces must be functioning properly to turn the automobile on.

If you hear a clicking sound as your turn the key inside the ignition or press the push-start button, the starter may be bad. This is the most common indicator. However, it can also die while in use. If this happens, you will be startled by a grinding noise before the vehicle kicks the bucket.

Another sign that the start needs to be replaced is if you try to turn on the car and only the dashboard lights up. Other issues can conclude smoke coming from short circuits or blown fuses, an oil leak, or no response from the motor after performing a jumpstart.

To make sure that the culprit is the starter, you should first check the battery and its cables. Next, gently tap the starter a few times like you would an old TV. If neither of those things works, put the transmission in neutral and try to turn the engine on. Lastly, make sure that you have fuel in the tank.

Contact Ford Parts BC to get a new starter.

No matter what type of vehicle you own, it comes with a suspension system. Designed to provide you with a smooth, safe experience on the roads, this intricate mechanism has a lot of moving parts.

In a sense, it is somewhat like a carriage that the body of the automobile sits on. Connected to the wheels, it ensures stability. The following parts are included on most suspensions:

• Spring: These help control the load and height.
• Shocks: Sometimes referred to as dampers, they absorb kinetic energy (bumps).
• Anti-Sway Bar: Combined with the steering unit, it shifts movement to the appropriate wheels.

Most cars have a front and back suspension system. These can be either independent or dependent. Soaking up the energy that gets transferred through the wheels, they keep you and your passengers feeling level even on the worst streets. Maximizing the friction between the tires and the pavement, the handling becomes easier.

It’s also worth noting that the suspension extends the life expectancy of your car, truck, van, or SUV. Durability is improved as well, and it protects other mechanisms from potential damage such as hitting potholes.

Need to replace a piece of your suspension system? Contact the team at Ford Parts BC to find the correct pieces to match your model.